Outside Tap Installation

We install outside taps on suitable external walls, routing pipework from a nearby cold-water supply and fitting an accessible internal isolation valve. Installations are completed with secure supports, neat wall penetrations and appropriate backflow protection where needed. Advice is provided on frost prevention, hose use and ongoing care.

Planning the outside tap

A good installation starts with locating a convenient, practical position close to an internal cold-water supply. We check routing to avoid exposed pipework and choose a comfortable tap height for use with hoses, watering cans or buckets.

We consider access to an internal isolation valve and the best way to conceal or protect pipework while keeping it serviceable.

• Select site near an internal cold-water connection
• Avoid unnecessary exposed runs of pipe
• Position tap for practical use and accessibility
• Plan for an accessible internal isolation valve
• Neat wall penetration and sealing

Water supply protection and backflow prevention

Hose connections can allow contaminated water to be drawn back into the drinking-water system. Appropriate protection devices or installation methods are fitted to reduce this risk.

We check the existing plumbing and advise on suitable backflow prevention options for the property while ensuring the external tap can be isolated internally.

• Assess need for backflow prevention
• Fit suitable protection where required
• Ensure accessible internal isolation valve
• Follow safe connection practices

Frost protection and maintenance advice

To reduce the risk of frost damage, disconnect hoses during cold weather and, where possible, isolate and drain the external section after use. We explain how your installation should be winterised.

We also offer basic maintenance tips so the tap and fittings remain tidy and serviceable over time.

• Advice on winter draining and isolation
• Recommended hose disconnection in cold weather
• Guidance on periodic checks for leaks
• Tips to keep external fittings tidy and secure

How we carry out the installation

Work begins with a site check, locating the cold-water feed and planning the pipe route. Pipework is securely supported and concealed where practical, with neat wall entry and sealing.

We finish by testing the tap, demonstrating isolation and protection features, and leaving the area tidy.

• Site assessment and route planning
• Securely supported pipework and neat finishes
• Fit isolation valve and any protection devices
• Test operation and leave work area clean

Frequently Asked Questions

Where is the best place to fit an outside tap?

A position close to an internal cold-water supply and at a practical height for hose use is usually best. We assess the site to avoid long exposed pipe runs and to provide convenient internal isolation.

Do outside taps need backflow protection?

Hose connections can create a backflow risk; whether a specific device is required depends on the installation and use. We can advise on suitable protection and fit the appropriate solution if needed.

How can I protect my outside tap from freezing?

Disconnect hoses during cold weather and, where the installation allows, isolate and drain the external section. We will explain how your particular installation should be winterised.

Will the installation make a mess of my wall or garden?

Installations are planned to minimise visible pipework and to make neat wall penetrations. Pipework is securely supported and the area is left tidy after work, though some disturbance can be unavoidable depending on routing.

Can you install an outside tap if I don’t know where the internal stopcock is?

We can locate the nearest suitable cold-water feed as part of a site visit and advise on where an isolation valve should be positioned for the external tap.